Instructions for Use, Building- in and Connecting
27
Installation instructions
Caution !
•
To avoid any possible hazard, the appliance
may be installed by qualified personnel only.
•
Panels and furniture lining of the kitchen
cabinet receiving the hob must be treated with
temperature resistant adhesives (100°C),
otherwise they might be discoloured or
deformed because of inadequate temperature
resistance.
•
The cooking hob is intended for building into the
worktop above the kitchen element of 600 mm
width or more.
•
After the installation of built-in hob make sure
that there is free access to the two fixing
elements in front.
•
Suspended kitchen elements above the
cooktop must be installed at such distance to
provide enough room for comfortable working
process.
•
The distance between the worktop and the
hood must be at least such as indicated in the
instructions for installation of the kitchen hood,
but in no case it may be less than 650 mm.
•
The smallest distance between the edge of the
appliance and the adjacent high kitchen
cabinet is 100 mm.
•
The use of hard wood decorative borders
around the worktop behind the appliance is
allowed, in case the minimum distance remains
as indicated on the installation illustrations.
•
Minimum distance between the built-in cooktop
and rear wall is indicated at the illustration for
the installation of the built-in cooktop.
•
The appliance may be installed in any worktop
with a thickness from 30 mm to 50 mm.
Dimensions of the built-in hob opening
•
Only the type EVP4…, ovens with cooling fan
can be inserted below gas cooking hob.
•
Prior inserting the oven, it is necessary to
remove the rear kitchen element panel in the
area of the oven opening. Equally, the front part
of the element must have an opening of no less
than 6 mm.
Installation procedure
•
Worktop must be placed absolutely horizontal.
•
Suitably protect the edges of the cut aperture.
•
By means of the supplied screws (4) fasten the
supplied tightening brackets (4) to the front and
the rear side of the cooking hob and to the
prepared aperture.
•
Connect the cooking hob to the mains power
supply and to the gas supply (see instructions
for the connection of the cooking hob to mains
power supply and gas supply)
•
Stick the supplied self-adhesive seal to the
bottom edges of the cooking hob.
•
Insert the hob into the cut aperture.
•
Press the hob firmly towards the worktop from
above.
•
For screwing down the fixing clip it is not
allowed to use screws longer than 6,5 mm.
