Gorenje GDV642X A, Руководство по эксплуатации

Страница: 5 / 32

FILL UP THE SALT
Before you begin using a dishwasher with a water
softener, you must fill the salt compartment with
salt. Use large grain salt or special dishwasher salt.
WARNING!
Top up the salt just before running a
programme. To avoid the risk of rust stains, the
dishwasher must be rinsed immediately after
topping up the salt.
WARNING!
Never pour dishwasher detergent into the salt
compartment. This destroys the water softener!
Do as follows the first time:
1 Unscrew the lid as illustrated.
2 Place the funnel supplied with the dishwasher
in the salt compartment top-up hole. First,
pour in about 1 l of water.
3 Then add salt, a maximum of 1.5 kg, until the
compartment is full.
4 Wipe up any excess salt so that the lid can be
screwed on firmly.
5 Run a programme to ensure that any salt in
the dishwasher is rinsed away.
Salt compartment lid
REFILL SALT INDICATOR
When the salt needs topping up, the above
symbol lights on the display.
When the salt runs out, unscrew the cap and fill
the container with salt. Water is only needed the
first time! Wipe clean and tighten. Run a
programme to ensure that any salt in the
dishwasher is rinsed away.
NOTE!
After topping up, it may take a while before the
symbol goes out.
TOP UP WITH RINSE AID
Drying is faster if you use rinse aid.
1 Open the rinse aid compartment lid.
2 Carefully top up with rinse aid. Only add rinse
aid to the level marked max.
3 Wipe up any splashes of rinse aid around the
compartment.
4 Close the lid firmly.
SELECTING THE RINSE AID DOSAGE
Rinse aid dispensing can be set from (Off)
to (High dose). (Factory settings: )
Increase the rinse aid dosage:
• If the dishes have water marks.
Reduce the rinse aid dosage:
• If the dishes have a sticky white/blue film.
• If the dishes are streaked.
• Build-up of foam. If you have very soft water,
the rinse aid can be diluted 50:50 with water.
SETTING THE RINSE AID DOSAGE
The section Settings describes how to set the rinse
aid dosage.
5