EN 13
Use special glass ceramic cleaners for stubborn dirt.
Observe the manufacturer's instructions. Be sure to
thoroughly remove any cleaner residues after the
cleaning process as they may damage the glass
ceramic surface when the cooking zones heat up.
Remove stubborn and burnt residues with a scraper.
Be careful when handling the scraper to prevent
injury.
Only use the scraper when dirt cannot be
removed with a wet cloth or special cleaners for
glass ceramic surfaces.
Hold the scraper at the correct angle (45° to 60°).
Gently press the scraper against the glass and slide
it over the signage to remove the dirt. Make sure the
plastic handle of the scraper (in some models) does
not come into contact with a hot cooking zone.
Do not press the scraper perpendicularly
against the glass and do not scratch the hob surface
with its tip or blade.
Immediately remove any sugar or sugar-laden food
from the glass ceramic hob using a scraper, even if
the hob is still hot, as sugar may permanently
damage the glass ceramic surface.
Discolouration of the glass ceramic surface
does not affect the operation or stability of the
surface. Such discolouration is most commonly a
result of food residues burnt onto the surface, or it
may be caused by some cookware materials (such
as aluminium or copper). Such discolouration is very
difficult to remove entirely.
Note:
Discolouration and similar flaws only affect the
appearance of the hob and do not directly affect its
function. Removing such flaws shall not be covered
by the warranty.
OVEN
Clean the oven walls with a damp sponge and
detergent. To clean stubborn stains burned into the
oven wall use a special detergent for enamel. After
cleaning carefully wipe the oven dry. Clean the oven
only when it is completely cold. Never use abrasive
agents, because they will scratch enameled surface.
Wash the oven utensils with a sponge and
detergent. You can also use special detergents to
remove rough stains or burns.
USING THE
„AQUA CLEAN“
FUNCTION
Turn the COOKING SYSTEM SELECTOR KNOB to
position
AQUA
CLEAN
.
Set
the
TEMPERATURE KNOB to 70°C.
Pour 0,6 l water into a baking tray and place it in the
lower guide.
After 30 minutes, food residues on the oven enamel
walls will have softened and they will be easy to
clean with a damp cloth.
Use the
“AQUA CLEAN“
system when
the oven has fully cooled down.
REMOVING AND CLEANING WIRE AND
TELESCOPIC EXTENDIBLE GUIDES
Only use conventional cleaners to clean the guides.
Hold the guides by the bottom side and pull them
towards the center of the oven cavity.
Remove them from the openings at the top.
Do not clean the extendible guides in
the dishwasher.
INSTALLING THE CATALYTIC INSERTS
Only use conventional cleaners to clean the guides.
Remove the wire guides or extendible guides.
(depending on the model)
Mount catalytic inserts onto the wire guides. The
upper part of the guides must be mounted into the
upper openings "A" in the catalytic inserts.
