GÖLZ FB 20 P, Оригинальная инструкция по эксплуатации и список запасных частей, Страница: 6 / 24

FB 20 P
- 6-
5006194-00
BA-E
For stand-mounted drilling the machine may have the following
•
a personnel safety switch (RCCB or PRCD) on the machine itself or
•
a coded (1 h) plug, which is connected to the 115 V mains via a safety box (IP44) with an RCCB.
The FB 20 P has in both types, voltage 110 V and 230 V, an integrated PRCD-safety switch in the cable.
The core drilling machines comply with the regulations of the “Stone and Earth” professional association dated
July 1989. They are machines of category II, which means that they must be mounted on stands and stable
(pursuant to DIN 57100 and VDE 0100), and the stand must be fitted with the following
•
reversing lock
•
water extraction device.
2.2 Safety
The following points are to be given special attention:
•
the technical data and details of the permitted use of the machine (commissioning, ambient and
operating conditions) which are set out in the catalogue, the operating manual, the model plate data and
other product information,
•
the relevant accident prevention regulations
•
the correct use of tools
•
the use of personal safety equipment
3.
Transport and storage
3.1 Transport
3.2 Storage
If possible, the storage site should be dry, clean and have a constant temperature. To ensure that the film of
lubricant in the bearings and sealing system is not lost, the motor shaft should be turned through several
revolutions by hand after a lengthy period of storage, for example at monthly intervals. The roller bearings in the
motors should be replaced (or regreased) if the period between delivery and commissioning is over four years. If
the machines are stored in adverse conditions, this period may differ considerably.
The machine is a pure wet drill machine.
Dry drilling can cause damage to the shaft sealing rings.
Before using the machine for the first time, check that the conformity of the data on the
model plate with the mains voltage and frequency. Voltage deviations of ± 5 % and/or
voltage deviations of ± 2 % are permissible. Repairs must only be completed by quality
persons who have suitable training and qualifications.
The machine is to be checked for signs for transport damage on receipt. Any damage must
be documented in writing.