119
GENERAL DOOR PANEL INSTALLATION
DOOR PANEL INSTALLATION
This programming mode allows to assign to a monitor / telephone a push button of the general door
panel that it wishes to call.
Before the push button of the general door panel must be programmed with backbone and
monitor/telephone code, (see page 118).
Programming the monitor/telephone:
Locate the SW2 configuration dip switch of the general door
panel to program, placed at the upper left side (back) of the
sound module. With the switch 1 to OFF and 3 to ON, set the
switch 2 to ON: to show that the system is ready for
programming, the general door panel will reproduce a tone.
Then program the monitor/telephone, as it is described in the page 128 (monitor), 131 and 135
(telephone), (see manual T1ML if the monitor/telephone is Platea Uno, T-740 Uno or T-940
Uno).
Bear in mind the configuration dip switch (as it is described in the previous step).
rogramming the monitors and telephones from a general door panel.
P
escription of the function connector CN5.
D
The function connector Cn5 is located at the upper left side of the back of
the sound module.
Plug the cable that is supplied with the module, to realize the following
functions:
10
1
9
2
8
3
7
4
6
5
Top view CN5
Description connector CN5
ð
"AP" function: It activates the relay of the lock release "CV1" and "Cv2", configurable activation
time of 3 or 15 seconds via dip switch SW1-2 (page 115), see connections (page 149).
ð
"ICO" function: For the busy channel indication, it will be realized with terminals "ICO" and "+12".
ð
"Handicap" function: Synthese vocale from FDI (France). The connector includes all wires for
connection (see page 149).
1 Grey (-) Ground.
2 Brown (+12) 12Vdc for activation the lock release.
3 White
(ICO) Busy channel indicator.
4 Yellow (AP)
External push button to activate the lock release.
5 Violet (+H)
For activation of an external illumination.
6 Blue
(OP)
Handicap.
7 Orange
(SC) Handicap.
8 Green
(ALM) Handicap.
9 Red
(PDB)
Handicap.
10 Black (-)
Ground.