golmar SV-220S, Инструкция по эксплуатации

Страница: 48 / 48

Golmar se reserva el derecho a cualquier modificación sin previo aviso.
Golmar se réserve le droit de toute modification sans préavis.
Golmar reserves the right to make any modifications without prior notice.
golmar@golmar.es
www.golmar.es
47
TROUBLESHOOTING HINTS
O
Nothing operates.
w
Check the output power supply voltage between ' ' and '+' is of 17Vd.c. Otherwise,
disconnect the power supply from the installation and measure again. If its correct now, it
means there is a short circuit in the installation. Disconnect the power supply from the
mains and check the installation.
w
Check the polarity wiring.
w
On installations with only one monitor, check the monitor is configurated as masterl, (see
page 41).
w
On installations with two monitors, check the monitor connected to door panel(s) has been
configurated as master and slave the other monitor, (see page. 41).
O
Monitor don't receive calls.
w
Check the output power supply voltage between ' ' and '+' is of 17Vd.c. Otherwise,
disconnect the power supply from the installation and measure again. If its correct now, it
means there is a short circuit in the installation. Disconnect the power supply from the
mains and check the installation.
w
Check the polarity wiring.
w
On installations with only one monitor, check the monitor is configurated as masterl, (see
page 41).
w
On installations with two monitors, check the monitor connected to door panel(s) has been
configurated as master and slave the other monitor, (see page. 41).
O
Don't listen the monitor ring tone.
w
Check the monitor call volume is not in "mute" position, (see page. 41).
O
Inappropiate audio level.
w
Adjust the audio levels as shown on page 37.
O
Does not work the intercom.
w
Remember that this function is only possible on installations with two monitors.
w
Check the intercom function steps have been realized correctly, (see page 44).
w
Check wiring between monitors is correct, (see page 45).
O
Door open function no operates.
w
Remember that this function is only available during call, communication and autoswitch-on
progresses.
w
Check the lock release and its wiring.
–
–