43
44
MONITOR INSTALLATION
ing tone selection.
R
ntercom function.
I
ix the monitor.
F
hanging the front film.
C
The monitor is supplied with a reversible front film, that allow the owner
to choose between two colors.To change the front film, remove
the front plate by inserting a plain screwdriver in the
triangle marks, as it is shown on the drawing.
It's possible to select for each monitor between four different ring tones.
To select a ring tone:
1. Press the push button to play the selected ring tone.
2. Press the push button to play the next ring tone. Repeat this stage till find the
desired ring tone.
3. To save the desired ring tone and exit press the push button .
The monitor exit of the ring tone selection to the 40 seconds, saving the last selected
ring tone.
Platea-22 monitor, incorporate as standard the intercom function between two monitors of the
same apartment. To enable this function check the following conditions:
- The monitor that is connected to door panel(s) has been configurated as master and slave
the other monitor.
- Link the 1, 2 and 3 terminals of the units (see page 45).
To stablish an intercom communication lift the handset and press the intercom push button on
the calling monitor: acoustic tones will be reproduced on the handset confirming the call is in
progress, the called monitor will receive the call. To establish communication, lift the handset
of the called monitor. To finish the communication, press the push button at any of the
monitors. If during an intercom communication a call is made from the door panel, the
intercom function will be cancelled, establishing audio and video communication between
the door panel and the master monitor.
.
.
.
.
ix the monitor connector to the wall.
F
Avoid to place the monitor near to heating sources,
in dusty locations or smoky environments.
To install the monitor directly over the wall,
drill two holes of Ø6mm. and use the supplied screws.
The upper part of the monitor connector must be placed
at 1,60m. height roughly. The minimum distance
between the monitor connector and the closest object
must be 5cm.
Place the monitor at right angles to the connector
and align the attaching holes of the monitor
with the attachment hooks of the connector,
as it is shown on the drawing.
Lock out the monitor. Press the right side
till the attachment clip locks the monitor
firmly.
To disassemble the monitor from the connector,
use a plain screwdriver to release the
attachment clip. Remove the monitor from
the connector, with special attention do not
falls.
MONITOR INSTALLATION
