37
all volume control.
C
38
onfiguration jumper 'JP2'.
C
MAX
OFF
JP2
SW2
Linked telephone to call push button 1 (apartment 1).
System of 1 apartment, JP2 must be inserted.
Linked telephone to call push button 2 (apartment 2).
JP2
JP2
*Factory default.
ntercom function.
I
The
, incorporate as standard the intercommunication function
T-772VD telephone
between two
units of the same apartment.
To stablish an intercom communication lift the handset and press the intercom push button
on the calling telephone: acoustic tones will be reproduced on the handset confirming the
call is in progress, the called telephone will receive the call. To establish communication, lift
the handset of the called telephone.
If during an intercom communication a call is
made from the door panel, acoustic tones will be heard on the handset of both telephones.
To establish communication with the door panel, it must end the intercom and the visitor
back to make the call from the door panel.
.
The communication will last for 90 seconds or until the
handset is replaced in any of two telephones.
Call push button (1 apartment):
Call to apartment 1.
Call to apartment 1.
1
2
Call push button (2 apartments):
Call to apartment 2.
Call to apartment 1.
1
2
TELEPHONE DESCRIPTION
ix the telephone to the wall
F
.
It is necessary to open the telephone for wiring and fixing
purposes To open the telephone, insert a plain
screwdriver into the slots and gently lever as shown in
the drawing
.
.
P
. C
.
.
ass the installation wires through the corresponding hole and connect
them as shown on the installation diagrams
lose the telephone as
shown on the picture Once the telephone is closed, connect the
handset using the telephone cord and put it on the cradle
Avoid placing the telephone near sources of heat, in dusty
locations or smoky environments The telephone can be
fixed using an electrical embedding box or directly on the
wall, as shown on the picture If the telephone will be
installed directly over the wall, drill two holes of Ø6mm on
the specified positions, using 6mm wall plugs and Ø3.5 x
25mm screws
.
.
.
TELEPHONE INSTALLATION
The telephone allows to regulate the call volume with a maximum,
medium and off value. With the help of the switch of three positions
placed in the right front of the telephone.
Only if the door panel has been configurated for a system of 2 apartments
(see page 33), the JP2 configuration jumper of the telephone, allows to
link the telephone of the apartment to a call push button of the door
panel. The JP2 jumper is placed inside of the telephone.
Important: If the door panel is configurated for 1 apartment, the JP2 jumper of the
telephone must be inserted.
