Goldmund MIMESIS SRM2.3, Руководство пользователя

Страница: 4 / 7

4
4 - CONNECTIONS
Check if volume control is down to zero on the preamplifier.
First, connect the interconnects between the preamp and each of the power amps.
Connect the speaker cables to the red and black terminals accessible at the back of the amplifiers.
You may notice that the ground of the input and the black speaker terminal are of the same polarity.
The amplifiers are non-inverting in phase.
Then, connect the power cords to the back of each amplifier and plug them in the nearest wall plug.
Use a 3 lugs grounded plug, for safety reasons. To get the best sound of the amplifiers, avoid any
multiple plug or extension cord.
5 - AMPLIFIERS CONTROLS
On the front plate of the GOLDMUND MIMESIS SRM2.3 amplifier you will find only one switch : The
POWER key, used to power the amp on.
When turned ON the channel is immediately connected and the POWER led lights up.
The amps may be powered off by turning off the POWER switch at any time. The led will fade very
slowly, indicating discharge of the filter capacitors. The speakers will be disconnected after a few
seconds.
It is absolutely normal that a slight sound is heard from the speakers when the amplifiers are turned
ON or OFF. The SRM2.3 is self-protected and the sound heard is corresponding to the charging and
discharging of the capacitors.