13
Configuration Menu Items
Each item needs to be programmed and may contain additional sub-menu items. Refer to the following
pages for information on programming.
Filter Config.
+ to view/change
Filter Pump
1 Speed
Freeze Protect
Enabled
+
+
+
>
>
>
>
>
>
Push to access pump options
Toggle between 1-speed (default) and 2-speed options
Toggle between Enabled and Disabled Freeze Protection
Move to next menu item
Move to previous/next configuration menu
Move to next menu item
Filter Pump
For 2-speed pumps: When a 2-speed pump is configured, either the AUX1 or AUX2 relays
must also be configured to control the low speed motor winding on the pump .
CAUTION: Incorrect programming may result in pump damage--consult with a pool profes-
sional before making any changes.
Freeze Protection
Freeze protection is used to protect the pool and plumbed equipment against freeze damage.
If freeze protection is enabled and the AIR temperature sensor falls below 38°F, the Aqua
Logic will turn on the filter pump to circulate the water. If “Pool and Spa” is selected in the
Pool/Spa sub-menu (see page 20), the valves will also alternate between the pool and spa
every 30 minutes.
Heater1 Config.
+ to view/change
Heater1
Disable
Heater Cooldown
Disabled
Heater Extend
Disabled
+
+
+
+
>
>
>
>
>
>
>
>
Push to access heater options
Toggle between Enabled and Disabled (default) Heater 1
Toggle between Enabled and Disabled (default) Heater Cooldown
Toggle between Enabled and Disabled (default) Heater Extend
Move to previous/next configuration menu
Move to next menu item
Move to next menu item
Move to next menu item
if “Heater” is enabled
if “Heater” is enabled
Heater 1
If the heater is “Enabled”, the heater relay will turn on when the water temperature is less
than the desired temperature setting and the filter pump is running. The desired temperature
is in the “Settings Menu”. If applicable, the homeowner will be prompted to enter separate
“pool” and “spa” settings. Depending on the position of the pool/spa suction valve, the
proper temperature setting will be used.
Heater Cooldown
This feature ensures that the heater cools down before water circulation is stopped. When
enabled, The Aqua Logic will continue to run the filter pump for 15 minutes after the heater
turns off. During this period the filter pump LED will flash and also a “Heater Cooldown,
Filter Pump On’ message will scroll on the display.
When the filter pump is running and the heater is on: Pressing the “Filter” button once will
cause the heater to turn off, but the filter pump will continue to run for heater cooldown (filter
LED flashing and message on display). Pushing the filter button a second time will override
the heater cooldown operation and turn the filter pump off.