7
The Settings Menu and the Timers Menu are the menus you will be using most often to adjust the operation
of your pool. The Configuration Menu is used when the system is installed and defines what equipment is
connected to each output and the operational logic that will control the equipment. This menu is normally
“locked” and should only be used by a pool professional. Details regarding the Configuration menu are
included in the Aqua Logic Installation Manual.
The “Diagnostic Menu” is primarily intended for the service technician and contains information and details
about the system operation that are helpful in troubleshooting, if problems occur.
Settings Menu
The Settings Menu allows you to set all system operating parameters except the timeclock and countdown
timers which are part of the Timers Menu.
Spa Heater1
102°F
+
>
>
Adjust the desired spa temperature (off, 65°F, 66°F, ...103°F, 104°F, off)
Move to previous/next menu item
The spa heater setting will only appear if the system has been setup for “spa only” or “pool
and spa” operation and the heater control is enabled. The heater will turn on whenever the
pool/spa valves are in the “spa only” position and the filter pump is running and the spa
water temperature is less than the desired temperature setting. If you have both solar heat
and a conventional heater and the solar priority option is selected (Configuration Menu),
then the conventional heater will only operate when solar heat is NOT available.
Pool Heater1
Off
+
>
>
Adjust the desired pool temperature (off, 65°F, 66°F, ...103°F, 104°F, off)
Move to previous/next menu item
The pool heater setting will only appear if the system has been setup for “pool only” or “pool
and spa” operation and the heater control is enabled. The heater will turn on whenever the
pool/spa valves are in the “pool only” or “spa spillover” position and the filter pump is
running and the pool water temperature is less than the desired temperature setting. If you
have both solar heat and a conventional heater and the solar priority option is selected
(Configuration Menu), then the conventional heater will only operate when solar heat is
NOT available.
Spa Solar
104°F
+
>
>
Adjust the desired spa temperature (off, 65°F, 66°F, ...103°F, 104°F, off)
Move to previous/next menu item
The spa solar setting will only appear if the system has been setup for “spa only” or “pool
and spa” operation and the solar control is enabled. The solar system will turn on whenever
the pool/spa valves are in the “spa only” position and the filter pump is running and the spa
water temperature is less than the desired temperature setting and solar heat is available.
Pool Solar
88°F
+
>
>
Adjust the desired pool temperature (off, 65°F, 66°F, ...103°F, 104°F, -off)
Move to previous/next menu item
The pool heater setting will only appear if the system has been setup for “pool only” or “pool
and spa” operation and the solar control is enabled. The solar system will turn on whenever
the pool/spa valves are in the “pool only” or “spa spillover” position and the filter pump is
running and the pool water temperature is less than the desired temperature setting and solar
heat is available.
