23
adjust the time, the control panel will flash and the emitters will stop generating heat. Once you
set the time to the desired setting, then press the START/WORK button twice and the control
panel will stop flashing and heat will began coming from the emitters once again.
5. Heating times do vary. Generally, it will take approximately twenty to thirty minutes to preheat the
sauna to approximately 115 degrees Fahrenheit/46 degrees Celsius. When the ambient temperature
is low, heating requires additional time. For the first few times of use, you may use 115 degrees
Fahrenheit/46 degrees Celsius as a reference starting point for a time period of about 15-30 minutes
(this represents the actual time you are in the sauna at the desired temperature). As you become
more comfortable and familiar with the sauna, you can increase the temperature and time period
according to personal preference.
6. When the temperature is at the set-up value, the temperature sensor will allow the sauna room to
maintain the set temperature. The WORK indicator light will remain on and the HEAT light will turn
off. The emitters will stop generating heat. Once the inside temperature drops approximately 4
degrees Fahrenheit, the HEAT light will turn back on and heat will again be generated by the
emitters. With the temperature sensor, the inside temperature will always remain around the set-up
value.
7. Reading lamps and/or roof lamps and/or color therapy lamps are operated by pressing the
respective buttons located towards the center of the control panel. These lamps are offered on
some models and are not available on all models.
8.
Chromotherapy/Color Therapy Lighting (optional)
can be operated as follows. First, you will
need to install the battery. Once the battery has been inserted into the remote, you are ready to
operate the chromotherapy/color therapy lighting system. Press the
“READING
LIGHT
”/”INTERIOR” button on the sauna control panel. The white light will come on. While
pointing the remote at the ceiling light, you can press any of the colors on the remote and that color
will be displayed. You can use the SHADE button on the remote to go through a sequence of
colors. If you want to turn the light off during your sauna session, you can press the POWER button
on the remote.
Please note: The Control Panel overrides the remote and you must be inside
the sauna room for the remote to work.
9. To operate the radio, press the power button to turn on the CD/RADIO player. Press the band to
choose between the FM/AM frequency on the radio. You must place the radio antenna above the roof
cover to receive a radio station signal. To use the CD function, insert the CD disk into the top (into the
CD slot) of the radio. If the CD player does not work, make sure the set screws on the top of the
CD/RADIO player have been removed. For more detailed instructions, please see the CD/radio
owner
’s manual.
Содержание GDI-6365-01
Страница 30: ...29 PAGE INTENTIONALLY LEFT BLANK ...
