Patriot
_SG_REVA_050714
4
ABOUT THIS SERVICE GUIDE
This service guide provides you with the information necessary to repair the Golden Technologies Patriot
scooter. There are two parts to the service guide: Troubleshooting and Component Replacement. The
Troubleshooting section will assist you in finding the source of the problem. The Component Replacement
section contains step-by-step replacement instructions for key components.
Before troubleshooting, check the following:
• Make sure that the circuit breaker is reset.
• Visually check terminals for corrosion. Check wires for missing insulation.
• Make sure that the batteries are in good working order.
When possible, keep sets of known good batteries of
various ratings in your shop at all times. The GR575 requires 75AH batteries. Problems that surface during
troubleshooting are often due to the fact that the batteries are not fully charged or cannot hold their charge.
•
Make sure that the electrical connections are secure.
Unplug the connectors and make sure all of the pins are
seated properly. Push the pins back into the connector housing if necessary.
If you get to a point during troubleshooting where you cannot continue, call tech
support at 800-624-6374.
GR575 COMPONENTS
The GR575 is a battery-operated scooter controlled by a P+G Drives S-Drive controller. The S-Drive controller
monitors the systems and displays BEEP codes when it detects a fault in the system. The GR575 was designed
to operate with between 18 – 24 volts (V) of direct current (DC).
The GR575 control system is made up of the following components:
• 12V/75AH Batteries (2)
• Battery Harness(es) (2)
• Main Circuit Breaker
• Off-Board Battery Charger
• Power Harness
• Motor Brake
• P+G S-Drive Controller
• Main Harness
• Dash
• Paddle (Throttle pot)
• Speed Pot
• Key Switch
• High/Low Switch
Parts and service must be authorized by Golden Technologies Service Department.
Unauthorized parts or service may void the warranty. For more information, contact the Golden
Technologies Service Department at 800-624-6374 or [email protected].
Component:
12VDC/75AH Batteries (2)
Location:
Connected in series inside the battery compartment.
Function:
Supply 24VDC to the motor and/or accessories (12VDC x 2).
Connections:
BAT+ and BAT- are located on each battery.
Failure Signs:
Batteries drain quickly. Scooter runs slowly or not at all. Batteries will not charge, but charger is
working properly. Beep Codes #2 and #3.
Tests:
Load test. Fully charge the batteries first. Make sure the charging system is working.
Expected Readings:
12 - 14VDC each when fully charged. 24VDC across the B+ and B- terminals of opposite
batteries.
Serviceable:
Replace battery.
Component:
Battery Harness(es) (2)
Location:
Connected to each of the batteries.
Function:
Supply 24VDC from the batteries to the S-Drive controller. (12VDC each battery x 2).
Connections:
BAT+ and BAT- are located on each battery.
Содержание PATRIOT GR575
