Golden PATRIOT GR575, Руководство по обслуживанию

Страница: 19 / 52

Patriot
_SG_REVA_050714
18
MOTOR/BRAKE REPLACEMENT
To replace the motor/brake assembly:
1) Place the freewheel lever in the engaged position.
2) Remove the key from the key switch.
3) Remove the seat.
4) Remove the battery cover.
(Optional: removal of the batteries will reduce the weight.)
5) Disconnect the motor and brake connections at the controller.
6) Remove the (4) Phillips screws that fasten the rear shroud and remove the shroud. See figure 11.
7) Cut the tie wrap(s) securing the motor/brake cable. See figure 12.
8) Remove the (2) 5mm Allen bolts (top and bottom bolts only) from the transaxle. See figure 12.
9) Slide the motor off the transaxle. Retain the motor coupler.
10) Install the motor coupler onto the shaft of the new motor/brake assembly.
12) Assemble in the reverse order.
Figure 11. Rear Shroud Figure 12. Motor/Brake Assembly
TRANSAXLE REPLACEMENT
To replace the transaxle:
1) Perform steps 1-7 of the motor/brake replacement instructions.
2) Place a support under the scooter frame forward of the u-brackets to raise the drive wheels off the ground to
allow removal of the transaxle. See figure 11.
3) Remove the center cap.
4) Remove the nut and washer that fastens the drive wheel to the axle. See figure 4 on page 16.
5) Remove the left-side drive wheel from the axle.
Retain the axle key.
6) Remove the right-side drive wheel.
7) Slide the drum off the transaxle. See figures 13 and 14 on page 19.
8) Remove the hand brake cable.
9) Remove the hand brake assembly.
Retain the axle key.
10) Remove the (2) 8mm bolts connect each u-bracket. Repeat on the opposite side. See figure 14 on page 19.
11) Remove the transaxle from the rear frame.
12) Assemble in the reverse order.
Screws
Bolts
(5mm)
Motor
Motor/Brake Cable