Golden PATRIOT GR575, Руководство по обслуживанию

Страница: 15 / 52

Patriot
_SG_REVA_050714
14
BEEP CODE #8 - MOTOR DISCONNECTED
Check the position of the freewheel switch. (Key must be turned off and back on to clear the fault code). The
motor has a bad connection. Check all the connections and leads between the motor and the S-drive.
1) Remove the seat.
2) Remove the battery cover.
3) Disconnect the motor harness from the controller. This is the large gray connector marked with the
symbol.
4) Make sure that the pins are seated properly on the motor harness.
4) Measure resistance across the motor + (thick red wire) and the motor – (thick black wire) on the motor harness.
• 50 ohms but not shorted? (NOTE: Can be as low as 0.2 ohms.) – replace the controller.
• Out of that range? – Go to the next step.
19) Remove the four brushes from the motor and inspect them. See figure 10 on page 17. Indications of a bad
brush include broken springs, cracked carbon, black or discolored wire, and black or discolored contacts.
• Worn or physically damaged? – Replace the brushes.
• Not worn or physically damaged? - Replace the motor/brake assembly.
BEEP CODE #9 – POSSIBLE CONTROLLER TRIP
A control system trip is indicated. Make sure all connections are secure.
1) Make sure that all connections are secure.
• If the code continues, then shut down the scooter and allow the controller to cool down.
• If the problem still persists, then replace the controller.