Compass Sport_SG_REVA_101014
18
Flash Code 7: Module Error (other than Remote)
A. Check the LiNX connections and wiring.
B. Check the battery voltage.
C. Check that the wiring is not damaged and that all cables are connected properly.
D. Make sure all pins are seated properly in their connectors.
E. If after performing the previous tests and the fault still persists, replace the LiNX power module.
Step 3: Check for other conditions displayed by the LiNX Control Unit.
Drive Inhibit
Drive inhibit mode is indicated by the battery gauge with a right-to-left light sequence.
The light sequence starts with the green LED on the right-hand side, and one-by-one, each LED will switch on
and then off. When the sequence completes at the left-most red LED, it begins again at the right-hand side.
The light sequence continues until the error condition has been cleared.
OONAPU
OONAPU (“Out of Neutral At Power Up”) is a safety feature that prevents accidental of the wheelchair, either
when powering up, or when the wheelchair comes out of an inhibit state.
If the LiNX LE System is turned on (or comes out of an inhibit state) while the joystick is not in the centre
position, an OONAPU
warning
is displayed. During an OONAPU warning, the battery gauge LEDs will flash
continually to alert the user, and the chair will not drive. If the joystick is returned to the centre position within
five seconds, the warning will clear and the wheelchair will drive normally.
However, if the joystick remains out of neutral for longer than five seconds, an OONAPU
error
will occur; the
error is displayed by the Status indicator flashing red, and the chair will not drive. To clear the error, return the
joystick to the neutral position and power the unit off and then on again.
Start
