Compass Sport_SG_REVA_101014
17
Figure 11
Figure 12
Flash Code 5: Left Park Brake Error
A. Make sure the left park brake lever is engaged.
If disengaged, re-engage the park brake lever and turn the power off and back on to reset flash code.
B. Check the resistance of the left park brake, to determine if the fault is in the park brake or in the controller.
Set your meter to the 200 ohm scale.
Touch the leads together to make sure the meter is accurate. You should have 0 ohms at this point. If not,
your meter needs to be calibrated.
Place the red and black meter leads on the two middle pins of the motor connector as shown in
figure 13.
Meter reading should be 80 ohms or less, but not shorted.
Any reading outside this range, replace the park brake.
C. If the reading is within range, and the controller still displays a flash code, check the wiring for visible
damage and that all cables are connected properly. Make sure all connectors are seated properly in their
connectors.
Figure 13
Flash Code 6: Right Park Brake Error
A. Make sure the right park brake lever is engaged.
If disengaged, re-engage the park brake lever and turn the power off and back on to reset flash code.
B. Check the resistance of the right park brake, to determine if the fault is in the park brake or in the controller.
Set your meter to the 200 ohm scale.
Touch the leads together to make sure the meter is accurate. You should have 0 ohms at this point. If not,
your meter needs to be calibrated.
Place the red and black meter leads on the two middle pins of the motor connector as shown in
figure 13.
Meter reading should be 80 ohms or less, but not shorted.
Any reading outside this range, replace the park brake.
C. If the reading is within range, and the controller still displays a flash code, check the wiring for visible
damage and that all cables are connected properly. Make sure all connectors are seated properly in their
connectors.
