![background image](http://html.mh-extra.com/html/goldair/gpdh400/gpdh400_operating-instructions-manual_2239904005.webp)
OSCILLATE
Press the SWING button to activate the oscillation
function.
CHILD LOCK
Press the CHILD LOCK button to lock the control
panel: press and hold the button for 3 seconds to turn
the function on, the indicator light will illuminate and
the unit will
“beep”, all other buttons will be
unresponsive; press and hold the button for another 3
seconds to turn the function off, the indicator light will
turn off and the unit will
“beep”.
PLASMA
Press the PLASMA button to activate the Ionizer (air
purifier) function.
The fan will begin to operate in Low speed and the
Louvre will rise and hold at the top.
Press the PLASMA button again to turn the Ionizer
(air purifier) off.
INDICATOR LIGHTS
Power Indicator: will be on when the machine is
working in the dehumidifying mode.
Water Tank Full Indicator: will be on when the water
tank is full and the machine will stop working.
Defrost Indicator: will be on when the machine is
defrosting; this light will be flashing when the
temperature sensor is open circuit or short circuit.
Plasma Indication: will be on when the PLASMA
function is activated.
Child Lock Indicator: will be on when the Child Lock
function is activated.
Swing Indicator: will be on when the oscillation
function is activated.
DEFROST
When
the
Dehumidifier
is
operating
in
low
temperatures the unit will go into a defrost cycle. This
is to remove any ice that has accumulated on the
interior of the unit as a result of its operation. The
temperature and humidity in the room will determine
how often the Dehumidifier goes into its defrost cycle.
This Dehumidifier is designed to provide an optimum
performance. It is not recommended to operate in
ambient temperature exceeding 35°C or Lower than
5°C.
MEMORY FUNCTION
If power supply is cut off when the appliance is
running, it will automatically restart in the last working
mode once power is restored.
Operating your Dehumidifier
FOCUS MODE:
Press the MODE button to select
the Focus mode, the air will stop coming out of the
front louvres and will come out from the vent on the
back of the machine. Connect the
“Y” pipe to the vent
to allow the dry air to pass through the pipe, this is
the shoe drying function.
IMPORTANT INFORMATION
When using the shoe dryer and focus mode, you
must
remove
the
green
filter
from
the
dehumidifier.
Failure to do so may result in the
unit over heating and shutting down. You should
replace the filter when finished with the shoe
dryer.
NOTE: If the power supply is interrupted suddenly,
the machine will stop for 3 minutes, then start again
automatically.
TIMER
There are two options when using the timer function:
When the Dehumidifier is running, you can set the
timer to turn off the unit after X amount of hours. In
order to do this, whilst the Dehumidifier is running
press the TIMER button twice, the digital Timer
display will flash. Use the Up and Down buttons to set
the length of time you want the unit to run before
turning itself
Off. The Timer will cycle through the
time settings in 1hr increments as follows; 00, 01, 02,
03, through to 12 hours.
Press the HUMID/TIMER button a third time to exit
the Timer setting function.
When the unit is off you can set the timer to turn the
Dehumidifier on after X amount of hours. In order to
do this, whilst the Dehumidifier is off (but still plugged
into a power outlet and switched on at the mains)
press the HUMID/TIMER button twice, the digital
Timer display will flash. Use the Up and Down
buttons to set the length of time before you want the
unit to turn itself On automatically. The Timer will
cycle through the time settings in 1hr increments as
follows; 00, 01, 02 ,03 through to 12 hours.
Press the HUMID/TIMER button a third time to exit
the Timer setting function.