Goldair GIR500, Руководство по эксплуатации

Страница: 9 / 16

Operating Your Heater
HIGH TEMPERATURE SENSOR FUNCTION
While the heater is working at full power (all four tubes of the heater are lit up), if the sensor of
the heater detects that the room temperature is higher than 38
°
C, the heater will adjust to half
power (two tubes of the heater are lit up). When the sensor detects the room temperature is
below 38
°
C, the heater will adjust back up to full power again.
OPEN WINDOW TEMPERATURE SENSOR FUNCTION
While the heater is working at full power, if the sensor of the heater detects that the room
temperature declines 5
°
C within 5 minutes, the heater will adjust to half power and the open
window indicator will light up. You can turn off the open window function by pressing any button
so that heater can resume heating at full power again.
HEATER OPERATION
Check that the power switch on the side of the appliance is set to the Off position before
plugging the heater into the mains supply.
Turn on the power switch on; you hear a short beep sound and the display panel will light up for
1 second. It will then automatically turn off and the power indicator
will light up; the heater
will be in standby mode.
While the heater is in standby mode, press the ON/OFF button and the heater will start working
in Normal mode. The room temperature is shown on the display when the heater starts.
NORMAL MODE
1. When Normal mode is first applied, the heater will start working at full power and the full
power
indicator will light up.
2. If you press the minus (-) button, the heater will start working at half power and the half
power
indicator will light up. If you then press the plus (+) button, the heater will start
working at full power again.
AUTOMATIC MODE
1. Press MODE to enter Automatic mode.
2. The automatic mode indicator “
☼
” will light up and the heater will start working.
3. You can press the plus (+) and minus (-) buttons to adjust the temperature between 15
°
C
to 32
°
C. The display will show the temperature that it is set.
4. The heater will begin operating at your set temperature after 5 seconds or immediately
after you press the SETTING Button again.
Note: When the temperature is set higher than the actual room temperature, the heater will
work at full power with all four tubes lit. When the temperature is set lower than the actual
room temperature, the heater will work at half power with only two tubes lit.