Operating your Dehumidifier
CONTROLS
Press
or
button to set the desired
humidity level in the room, which can be set from
30% to 90% at 5% intervals or on ‘CO’ for
continuous dehumidification.
Once the rooms humidity is lower than the selected
humidity by 2%, compressor will stop and fan stops
working 3 minutes later; When environment humidity
is equal to or higher than the selected humidity by
3%, compressor will restart.
TIMER
The timer can be set to turn the unit On or Off.
To set to turn on; Press the Timer button when the
unit is turned off. Press again until you reach the
amount of hours you would like to elapse before the
appliance turns on (1-24)
To set the timer to turn off: Press the Timer button
when the unit is turned on. Press again until you
reach the amount of hours you would like to elapse
before the appliance turns off (1-24)
WATER TANK FULL
A beep signal will sound 15 times. The WATER
FULL indicator light will illuminate on the control
panel.
The compressor will stop automatically, and the unit
will stop dehumidifying.
Empty the water container and replace it in the
correct position. If the drainage tank is dirty, wash it
with cold or lukewarm water. Do not use detergent,
scouring pads, chemically treated dust cloths,
gasoline, benzene, thinner, or other solvents, as
these can scratch and damage the tank and cause
water leakage
When replacing the drainage tank, press the tank
firmly into place with both hands. If the tank is not
positioned properly, the “TANK FULL” sensor will be
activated, and the dehumidifier will not operate.
Do not remove the float from the water tank. The
water full sensor will no longer be able to detect the
water level correctly without the float and water may
leak from the water tank.
The Dehumidifier will continue dehumidifying when
the compressor automatically restarts after
approximately three minutes.
WARNING Keep all objects at least 1 metre
from the front, sides and rear of the appliance.
WARNING: In order to avoid overheating, do
not cover the appliance.
WARNING: Never leave this appliance
unattended.
Leave the appliance to stand for one hour after
transport or after the unit has been on its side before
connecting it to the mains supply to let the refrigerant
settle.
Ensure that the water container is positioned
correctly.
Ensure all external windows and doors are closed
before turning on the unit.
Plug into power supply and switch on at the mains.
The dehumidifier will display the current humidity
level on the control panel. The POWER indicator light
will illuminate to show power to the unit.
The louvre to be opened by lifting the louvre at the
opening and pushing it upward.
To turn the Dehumidifier on, press the POWER
button.
Always choose a safe location for the Dehumidifier, keeping in mind the
safety precautions outlined. Ensure all packaging has been removed from
the unit before use. This appliance requires no installation, it should be
used solely as a portable appliance.
This dehumidifier is designed to provide optimum performance at 35°C -15°C but it is still effective down to
5°C. Ultimately the performance of this dehumidifier is dependant on the amount of moisture or water vapour
in the air.
