Gold Medal G-Whiz 5908, Инструкция по эксплуатации

Страница: 8 / 33

G-Whiz Gas Popper Model No. 5908 and 5908GGT
Page 8
gmpopcorn.com
Important Fire Safety Notice
Consult your local fire protection agency for your area’s requirements. Check local fire protection
requirements regularly to ensure compliance with local codes and proper operation. Have a fire
extinguisher near the unit. (Use only fire extinguishers approved for grease, oil, and electrical fires.)
DANGER
Hot oil is dangerous – severe burns can result when hot oil contacts the skin.
Hot oil is flammable – keep open flames away from hot oil and its vapors.
Keep a fire extinguisher near this unit.
Instruct personnel on what to do if there is a grease fire. DO NOT USE
WATER ON A GREASE FIRE! Use only fire extinguishers approved for
grease, oil, and electric fire.
002_102214
Checking For Gas Leaks
After making any gas connection, or after performing any work on the gas train, ALWAYS check
ALL gas connections for leaks with a soap solution.
DANGER
DO NOT use a match or flame to check for gas leaks – you may cause a fire
or explosion! When gas connections are complete, have a qualified
professional wire the unit to a power source which will carry the current
specified on the unit’s data plate.
034_042814
1. Apply SOAP BUBBLES to all connections and pressurize the gas line to check for leaks.
Perform this test outdoors away from any flames or sparks.
DO NOT use a flame to check for gas leaks.
2. It is recommended to check your flexible gas lines and gas fittings for wear and tear on
a frequent basis. Stop using the appliance immediately if damage is found, and contact
a qualified professional to inspect and correct any issue.
3. Securely route all gas lines away from flames and high temperature areas.
4. Contact Gold Medal Technical Support, or a qualified Gas Service Technician with any
questions.
Gas Pressure
We have determined that optimum popping occurs when the gas pressure is adequate. For
propane gas, we recommend a manifold pressure setting of 10 inches of water column. The
pressure is measured at the appliance when the main burner is ignited.
Lighting and Shutdown Instructions
When gas installation is complete, the unit must be connected to a power source prior to lighting
(reference the Electrical Installation Instruction section). For pilot and burner lighting and
shutdown instructions, refer to the Operating Instruction section of this manual.