Gold Medal G-Whiz 5908, Инструкция по эксплуатации

Страница: 22 / 33

G-Whiz Gas Popper Model No. 5908 and 5908GGT
Page 22
gmpopcorn.com
Troubleshooting
Issue Possible Cause Solution
Gas Issues A. For gas issues refer to the initial Gas Setup
Instructions.
Long Popping Cycles
(Longer than 4 minutes)
A. Inferior Corn A. Inferior quality corn would result in longer
popping cycles. Use only top quality hybrid
popcorn from reputable suppliers. Even then,
if you let your corn pick up moisture or dry
out, your popping cycles will be slow.
Kettle Agitator not
Rotating A. Kettle Motor Switch A. Check to make sure the unit has power and
the Kettle Motor Switch is ON. If the switch is
ON, and the agitator is not rotating,
DO NOT
pop corn. The switch may be faulty, contact
qualified service personnel for
inspection/repair.
B. Fuse (if equipped) B. Check the condition of the fuse. Replace if
required, if fuse trips again; contact qualified
service personnel for inspection/repair before
going any further.
C. Kettle Agitator Shaft/Stir
Blade not rotating.
(Unit
must be OFF, unplugged
and cool prior to
checking or adjusting
the agitator assembly.)
C. If the kettle agitator shaft is not rotating,
DO NOT pop corn. Check the clearance
between the kettle bottom and the stir blade;
it should be 1/32” (use a dime).