SmartBox
®
4 LAN / SmartBox
®
4 LAN PRO
10 / 28
part no. 28 410 57 a
START-UP
Operation elements and display
The device is adjusted once when it is put into operation. After start-up the device operates in
display mode with the top closed.
The display is a two-line LCD display with 2 x 16 characters.
The display has blue background lighting for best readability in all lighting conditions.
SmartBox
®
4 LAN has the following display:
The device is adjusted via the three small
blue buttons:
These are located on the
PCB between the
terminals.
Choose the language (German, English,
French) in menu step 18. LNames.
After the contents the display unit has been installed, it can be started up.
Activating power supply:
Keep away from the area of the 230 V terminal
!
Activate power supply – the following is displayed
PROGRAMMING
Overfilling of the tank due to incorrect entry values.
Operating media may leak. These:
•
are hazardous to water,
•
are category 1,2 and 3 inflammable liquids,
•
can ignite and cause burning,
•
may cause falling injuries due to slipping.
Enter these values with care!
The entry values are also retained in the event of the failure of the supply voltage.
Programming the level gauge
Before programming, you need to ascertain the tank data and enter the values into the right
column (Input value) of the following table. Then, enter the values for the individual entry
steps.
Setting a
parameter:
Press [ENTER] to open setup mode.
Select the desired setting parameter via [PLUS].
Press [ENTER] to call up the value selection for the parameter.
Set the value with [MINUS]/[PLUS], press [ENTER] to save.
Heat oil
0L
-0L
100%
Liquid
L
Fillspace L
%
