STROKE
OVER-STROKE !
MM INCH
10
5
0
0.4
0.2
DO NOT SET
0
STROKE
OVER-STROKE !
MM INCH
10
5
0
0.4
0.2
DO NOT SET
0
Drill or punch a Hole on
WORKPIECE, Hole diameter
should be 0.1 mm or 0.004” larger
than RIVET NUT diameter .
2
1
2
1
WORKPIECE
2
1
Insert the Screwed RIVET NUT into the Prepared Hole of
WORKPIECE to touch WORKPIECE . Squeeze 2 HANDLES
to touch REAR BODY , that drives THREADED MANDREL
downwards to deform RIVET NUT a Bulge against the back
of WORKPIECE to fasten RIVET NUT in the WORKPIECE.
RIVET NUT
2
3
H. HOW TO OPERATE THIS TOOL TO FASTEN RIVET NUT
1
Open 2 HANDLES fully.
Turn ROTATING KNOB Clockwise to screw RIVET NUT onto
THREADED MANDREL until RIVET NUT touches
NOSEPIECE. It is strongly suggested the RIVET NUT to touch
the NOSEPIECE Slightly, NOT HEAVILY! The Screwed RIVET
NUT should be flush with the THREADED MANDREL.
NOSEPIECE
3
2
1
4
1
REAR BODY
2
2
8
PRECAUSION:
Before operating this TOOL, it is strongly requested to follow the above "E" to install the correct size of
THREADED MANDREL and NOSEPIECE, the above "F" to adjust the proper Stroke Distance, and the above
"G" to adjust the Protruding Length (L) of THREADED MANDREL to ensure perfect fastening work between
TOOL and RIVET NUT.
[ WARNING ]
If hand force CAN NOT squeeze 2 HANDLES to touch
REAR BODY, DO NOT CONTINUE TO SQUEEZE 2
HANDLES, it may be caused by TOO LONG Stroke
Distance. REDUCE The Stroke Distance immediately
to protect this precious TOOL and RIVET NUT Thread
from damage. See TROUBLESHOOTING K-2).
NOTE:
It is always suggested to SQUEEZE 2 HANDLES WITH
BALANCED HAND FORCE to deform RIVET NUT a
Normal Bulge against the back of WORKPIECE.
SCREWED
RIVET NUT
WORKPIECE
PREPARED
HOLE
SCREWED
RIVET NUT
PREPARED
HOLE
WORKPIECE
WORKPIECE
1
GRIPPED
RIVET NUT
THREADED
MANDREL
Downwards
BULGE
3
SCREWED
RIVET NUT
NOSEPIECE
Flush With
THREADED
MANDREL
STROKE
OVER-STROKE !
MM INCH
10
5
0
0.4
0.2
DO NOT SET
0
Turn
ROTATING KNOB
Clockwise
