11
3.2
Connecting
3.2.1
Minifresh Vending Machine with Bubble Top ( 10 litre Water Reservoir)
1
Fill the water reservoir (Bubble top or any other container and connect to the inlet of the
Vending Machine).
2
Ensure that the dispenser is leveled.
3
Check that there are no kinks in the hose and that it is undamaged.
4
Check for possible leakage.
5
Check that the dispenser has been standing in its place for at least ½ an hour (to allow it to
acclimatise).
6
Check that the hose is not running over any sharp edges or hot surfaces.
3.3
Commissioning
1
Check that the wall
outlet socket on/off switch is set to “O” (OFF).
2
Insert the plug in the socket.
Switch to “I” (ON)
3
Set the on/off switch
of the Minifresh to “I” (ON). The switch should now light up (The ON /
OFF Switch is located at the back of the machine).The boiler now fills and starts to heat up.
4
Open the door of the machine with key.
5
Hold the Canister outlet up & slide the Canister out.
6
Insert Drink Flavour Inserts into the front key pad as per the Product Canister Configuration
if the machine is equipped with a interchangeable insert type as shown in the Fig 3-2. (Affix
the product stickers supplied, to the Canister to identify the product to be filled in, if supplied).
7
Fill Canisters with Product (Tea/coffee/milk/soup premix). The canister volume is 1.7 litre
and suitable for 1 kg of premix. While topping up, take care that the canister is filled up to
90% only.
8
Replace the Canisters back into the machine and close the door.
9
Wait until the display indicates “Please Rinse”. Press the “Rinse” key.
10 When Display
indicates “Welcome” & “Select Drink”, make your selection by pressing
respective flavour key.
11 Set the Minifresh to the required taste and quantities in accordance with the instructions
given in the programming section of this manual. Try each product several times to check
the setting.
12 Inform operator regarding importance of reading the operating instructions and keeping them
in a safe place.
WARNING!
The Minifresh must be allowed to acclimatize for at least half an hour
before it is connected to the mains voltage.
WARNING!
Never remove the inlet water connection tube when the machine is
ON. Always refill the water after switching the machine OFF.
Figure 3-2 : Beverage Flavour Inserts for Minifresh
Содержание Minifresh 2000
Страница 1: ...Item Code 06268406 Rev Date 12 May 2016 Minifresh hot beverage vending machine User Manual Rev 0...
Страница 27: ...27...
Страница 28: ...28 Dealer s Contact Details...