Godrej EON VESTA DWF EON VES 13Z SI STSL, Руководство пользователя

Страница: 6 / 29

2. INSTALLATION
2.1 Machine positioning
When positioning the machine, place it in an
area where dishes can be easily loaded and
unloaded. Do not put the machine in an area
where the ambient temperature falls below
0°C.
Read all warnings located on the packaging
before removing the packaging and
positioning the machine.
Place the machine close to a water tap and
drain. Take into consideration that the
connections will not be altered once the
machine is in position.
Do not hold the machine by its door or panel.
Leave an adequate distance around the
machine to allow ease of movement when
cleaning.
Ensure the water inlet and outlet
hoses are not squeezed or trapped and
that the machine does not stand on the
electrical cable while positioning.
Adjust the feet so the machine is level and
balanced. The machine should be placed on
flat ground otherwise it will be unstable and
the door of the machine will not close
properly. Do not place the machine in open
area where water splashing is prevalent .
2.2 Water connection
We recommend fitting a filter to your water
inlet supply in order to prevent damage to
your machine due to contamination (sand,
rust, etc.) from indoor plumbing. This will also
help prevent yellowish deposit formation
after washing.
WARNING: Use the new water inlet
hose supplied with your machine, do not use
an old machine's hose.
WARNING: Run water through the new
hose before connecting.
2.3 Water inlet hose
5
WARNING: Connect the hose directly to
the water inlet tap. The pressure supplied by
the tap should be a minimum of 0.03 MPa
and a maximum of 1 MPa. If the pressure
exceeds 1 MPa, a pressure relief valve must
be fitted between the connection.
WARNING: After the connections are
made, turn the tap on fully and check for
water leaks. Always turn off the water inlet
tap after a wash program has finished.
l How to Attach the “Magic” Hose Joint
1. Loosen the four screws and slide the top
of the Magic” Hose Joint (Section A in the
figure) onto the faucet. Then, securely
tighten the four screws provided with the
“Magic” Hose Joint using a screwdriver
to secure the top of the joint to the faucet.
2. Remove the CAUTION label from the
“Magic” Hose Joint.
3. Turn the male couple on the joint (section
B in the figure) clockwise to attach it
securely to the top of the joint (Section A
in the figure)
l
The appliance is to be connected to the
water mains using new water supply
Hose and “Magic” Hose Joint. Old hose
sets should be reused.
CAUTION:
If outer diameter of faucet is larger than
calbre of the Joint Ring, loosen the four
screws and remove the Joint Ring from the
“Magic” Hose Joint