Setting the Transmitter
Slide the Power Switch to ON, and the device is on and Status Indicator Lamp will not blink.
Note: In order to avoid power consumption, turn off the transmitter when not in use.
Power Switch
Slide the power switch to ON, and the AF lighting is allowed to output.
Power Switch of AF Assist Beam
Channel Setting
1. Short press the <CH/OK> Button until the
channel amount blinks.
2. Turn the Select Dial to choose the
appropriate channel. Press the <CH/OK>
Button again to confirm the setting.
3. This flash trigger contains 32 channels
which can be changed from 1 to 32. Set the
transmitter and the receiver to the same
channel before usage.
- 33 -
- 34 -
CH
Gr
Setting the Transmitter
Mode Setting
1. Short press the <MODE> Button, and the
mode of the current group will change.
2. To NON-GR grouping mode, all the groups’
modes will be changed simultaneously by
the order of TTL/M/Multi, in accordance
with Ratio flash mode. To GR grouping
mode, only the current group’s mode will
be changed by the order of TTL/M/--.
Current Group Settings
1. Short press the <GR> Button to set the
current group.
2. The current group settings will blink and
turn the Select Dial to change the settings.
3. When the current group is in the M mode,
the power output value is changeable from
1/1 full power to Min.[Note 1] power in 0.3
stop increments. When the current group
is in the TTL mode, the FEC amount is changeable
from -3 to 3 in 0.3 stop increments. When the current group is in the -- mode (flash
off), the amounts will not change.
4. Short press the <GR> Button again to confirm the setting.
[Note 1]
Min. refers to the minimum power output value that can be set in M/Multi mode.
X1C's minimum power output value is 1/128 for most of camera flashes. However, the value can
change to 1/256 when using in combination with Godox strong power flashes e.g. AD600, etc.
CH
Gr
CH
Gr
