Setting the Transmitter
Wireless Shutter Release Mode
Half press the <TEST> Trigger Button to focus. Fully press the <TEST> Trigger Button,
and the Status Indicator Lamp turns red. Now camera is ready to shoot. When releasing
the button, the Status Indicator Lamp turns off.
Setting the Camera
Use the External Flash Function on the camera to do the setting.
Note: 1. GR mode can only be used normally when attaching to the CANON EOS cameras that
issued after 2012.
If the camera model do not support GR grouping flash mode,
NON GR mode will be changed automatically.
2. In the NON-GR mode, Ration Off is steadily set in the TTL mode while A:B C is steadily set
in the M mode.
Setting the Receiver
Channel Setting
1. Short press the <CH> Button and the channel
amount will increase a step each time.
2. Long press the <CH> Button will enter quicker
adjustment mode. The channel amount will
increase fast in this mode.
3. Release the <CH> Button and the current
channel amount is confirmed.
- 41 -
- 42 -
Setting the Receiver
4. The channel amount will increase from 1 to 32. When the current channel is 32, press
the <CH> Button again and the channel 1 will be displayed on the panel.
Group Settings
4. The group amount will increase from A to E. When the current group is E, press the
<GR> Button again and the group A will be displayed on the panel.
1. Short press the <GR> Button and the group
amount will increase a step each time.
2. Long press the <GR> Button will enter quicker
adjustment mode. The group amount will
increase fast in this mode.
3. Release the <GR> Button and the current
group amount is confirmed.
Note: If the transmitter in the same channel is set to NON-GR grouping mode, the effective groups
of the receiver will change from A to C. Make sure the receiver 's group is set to A/B/C.
If the transmitter in the same channel is set to GR grouping mode, the effective groups of the
receiver will change from A to E.
Automatically Enter Power Saving Mode
1. The system will go into standby mode after the transmitter goes into standby mode.
And the displays on the LCD panel disappear now.
2. To wake up the system, press the <TEST> Button or the <GR> Button. Fully press the
<TEST> Trigger Button of the transmitter can also wake up the receiver’s system. If
the transmitter is attached to the CANON EOS camera, half press the camera shutter
can also wake up the system.
