Goddess DFE 947 DW9N, Инструкция по эксплуатации

Страница: 93 / 124

ENG
ENG - 93 ENG - 92
Connecting the water inlet hose*
Connect the cold water supply hose to a threaded 3/4 (inch)
connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that
the water is clear and free of impurities. If this precaution is
not taken, there is a risk that the water inlet can get blocked
and the appliance could be damaged.
Connecting the water outlet hose
m
ax
110
0 m
m
m
in 5
00 m
m
m
in 1
20 m
m
min 40 mm
Fit the drainage hose of your machine to the drainage pipe
without bending.
If the length of the hose is not sufficient, apply to
the authorized service for an extension made from the same
material as the original. Remember that the length of the hose
should not exceed 4meters even when with an extension.
If the drainage hose is longer the 4 m. the dishes will not be
cleaned properly secure your hose firmly to the drainage pipe
to avoid it coming off during the washing process.
Electrical connection
Before inserting the plug into the electrical socket, make sure that:
• the socket is earthed and complies with current regulations;
• the socket can withstand the maximum load of the appliance, which is indicated on the data
plate located on the inside of the door(see description of the appliance);
• the power supply voltage falls within the values indicated on the data plate on the inside of
the door;
• the socket is compatible with the plug of the appliance. If this is not the case, ask an
authorised technician to replace the plug (see assistance); do not use extension cables or
multiple sockets.
Once the appliance has been installed, the power supply cable and the electrical socket
should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it must be replaced by the manufacturer or its
Technical Assistance Service in order to prevent all potential hazards. (See Assistance)
The company shall not be held responsible for any incidents that occur if these regulations
are not observed.
Advice regarding the first wash cycle
After the appliance has been installed, immediately before running the first wash cycle,
completely fill the salt dispenser with and add approximately 1.2 Kg of salt (see Rinse aid and
refined salt). The water may overflow: this is normal and is not a cause for concern. It is also
normal that the LOW SALT indicator light continues to flash for a few cycles after the salt has
been loaded.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind
it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water
supply and drain hoses that can be positioned to the right or the left to facilitate proper
installation.
*For optional