Goddess DFE 947 DW9N, Инструкция по эксплуатации

Страница: 80 / 124

ENG - 81
ENG
ENG - 80
NOTE: If your model has no water softener, you may skip this section.
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the dishwasher,
deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses salts specifically designed to
eliminate lime and minerals from the water.
The salt container is located beneath the lower basket and should be filled as follows:
Attention!
Only use salt specifically designed for use in dishwashers! All other types of salt not specifically
designed for use in a dishwasher, especially table salt, will damage the water softener. In case
of damages caused by the use of unsuitable salt the manufacturer does not give any warranty
nor is liable for any caused damages.
Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split, remaining on
the bottom of the machine for any period of time, which may cause corrosion.
After the first wash cycle the control panel light expires.
1
2
A) Remove the lower basket and then unscrew and remove the cap from the salt container. 1
B) If you are filling the container for the first time, fill 2/3 of its volume with water (around
500 ml). 2
C) Place the end of the funnel (supplied) into the hole and introduce about 1.2 kg of salt. It is
normal for a small amount of water to come out of the salt container.
D) Carefully screw the cap back on.
E) Usually, the salt warning light will be off in 2 – 6 days after the salt container is filled with salt.
NOTE:
1) The salt container must be refilled when the salt warning light in the control panel
comes on. Though the salt container is filled enough, the indicator light may not black
out before the salt fully dissolve. If there is no salt warning light in the control panel (for
some models), you can judge when to load the salt into the softener by the cycles that
the dishwasher had run.
2) If there are spills of the salt, a soak program could be run to wipe them out.
C. FILL THE RINSE AID DISPENSER
Function of Rinse Aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, spot and
streak free drying.