Goboservice GOLED, Инструкция по эксплуатации, Страница: 5 / 17

GOLED
- 5 -
E
N
G
L
IS
H
1. SAFETY INFORMATION
Please read carefully the following safety instructions before do any operations. The product describes in
this instructions manual is a lighting fixture for the projection of a light beam. It is used usually to light,
with an high level of surface brightness, small areas on which to project decorative effects or fascinating
and special logos and images. The projector must be only used for the purpose it was designed and
built for. It is suitable to illuminate indoor and outdoor environments, any other use is not approved by
the manufacturer and for this reason disclaims any liability for damages resulting from improper or
incorrect use. This unit should be disposed of according to your country’s regulations regarding the
differentiated waste collection and disposal.
1. INSTALLATION – Please pay attention that during installation there is not
any hinders on the place on which the projector has to be installed. The
projector must be attached with dowels or screws or other anchorages
suitable with the material to be blocked. Make sure that all parts for fixing
the projector are in a good state of repair and check the stability of the
point of anchorage before positioning the projector.
2. MINIMUM DISTANCE OF ILLUMINATED OBJECTS – The projector
must be placed so that the objects hit by the beam of light are at least 0.5
meters from the lens of projector.
3. MINIMUM DISTANCE FROM FLAMMABLE MATERIALS – The projector
must be placed so that any flammable materials are at least 2,0 meters
from the projector lens and at least 1.0 meter from every point of the
fixture.
4. MAXIMUM AMBIENT TEMPERATURE- For a safe functioning of the
projector the temperature must not exceed 45°C.
5. PROTECTION AGAINST INDIRECTS CONTACTS - It is mandatory to
connect the projector to a mains supply system fitted with efficient
earthing (Class I appliance according to standard EN 60598-1).). It is,
moreover, recommended to protect the supply lines of the projectors
from indirect contact and/or shorting to earth by using appropriately
sized residual current devices.
6. CONNECTION TO MAIN SUPPLY - Connection to the electricity mains
must be carried out by a qualified electrical installer. Check that the
mains frequency and voltage correspond to those for which the projector
is designed. Evaluate if the mains supply can withstand the power
consuption of projector and, if it is, verify the maximum number of
devices that it is possible connect to the electricity line in order to
avoid overloading.
7. TEMPERATURE OF EXTERNAL SURFACE –The maximum temperature that
can be reached on the external surface of the fixture, in a thermally steady
state, is 60°C.
8. PROTECTION RATING - Direct exposure of the projector to rain, snow, hail