Protective Surface on
brackets goes facing
the pole to prevent
damaging the pole.
Back of Pole
1. Taking the longer U-bolt #3 slide it over the pole as shown
below,
. Please be careful not to scratch the paint
Detail 1
from your system, packaging foam can help with this.
Detail 2
Detail 1
2. Using the provided #7 washers with double stick tape. Stick
them on the inside of the lower brackets as shown in previous
page. Proceed to then slide the brackets over the U-bolt #3
and complete the rest of the lower assembly, see
. Do
Detail 1
Not Tighten Nut onto U-bolt yet, use only to keep other items
in place.
3. To attach the brackets to each other, pull them together until
one of the three holes on top bracket #1 align with the single
hole in the bottom bracket #2.
shows the location for
Detail 2
a 5 x 5, 5.5 x 5.5, 6 x 6, and 6 x 8 pole. Insert screw #9 and
tighten nut #10 to the bottom. After completing the assembly
should be just above the systems triangular gussets. At this
point, tighten U-bolt nuts #5 secure so that front to back
wobble is eliminated but rods and connectors can still pivot.
Figure 1
FRONT
OF
POLE
7
2
3
5
8
9
10
6
12
11
6
12
11
6
1
5”
5.5”
&
6x8”
6”
4
Two 7/16” Wrenches and one 9/16” Wrench will be required for the following steps.
4. Slide #11 Middle, #12 End & #6 poles together as shown in
Figure 1.
4
