BlueSense
GO Systemelektronik GmbH Faluner Weg 1 24109 Kiel Germany Tel.: +49 431 58080-0
Fax: -58080-11
Page 17 / 55
www.go-sys.de
5.1.1 Oxygen sensor setup (control parameter)
Sensors
From this menu you can set the parameters of the selected sensor.
The specific parameter setup is described in the sensor description.
Switch to the Calibration menu for the first sensor. § 5.1.1.1.
Switch to the Relay setup for the first sensor, § 5.1.1.2.
Switch to the Current Output setup for the first sensor, § 5.1.1.3.
Switch to the Change Name menu of the first sensor, § 5.1.1.4.
Switch between the units mg/l and %-saturation.
The button is also a status indicator.
Appears only if two measurement units are possible.
Switches to
•
the setting of the estimated minimum and maximum measurement value
of the sensor, needed for a connected BlueBox
•
the setting of the number of single measurements from which the meas-
urement value will be calculated by means of arithmetic averaging
•
to the setting of the measurement interval
see § 5.1.1.5
Switch back to the Sensors menu.
Switch to the Parameter Display.
