7
REV.01
INSTALLATION INSTRUCTIONS
© 2016 Go Rhino Products. All rights reserved
A section in each side of the upper and lower air deflectors must be removed to allow clearance for the
bracket assemblies.
Step-9 On each side of the lower air deflector, measure and mark the section between the two clips
and from the edge 1 ½”, then cut and remove the section, (Fig 7).
Step-10 On each side of the upper air deflector, measure and mark the section from the clip and from
the edge 3”, then cut and remove the section, (Fig 8).
3” x 5”
3” x 5”
Fig 7
Fig 8
Upper Air Deflector
Lower Air Deflector
