- 28 -
Wireless Heart Rate
Wireless Chest Belt Monitor
Your unit includes the pre-installed wireless heart rate receiver
With console. The Wireless Chest Belt is an option is not
Included with the equipment. To use the wireless interactive
Portion of the programming you can purchase the optional
Wireless Chest Belt with the Store .
STORAGE AND MAINTENANCE
Dry the chest belt monitor after each use. The chest
belt monitor is activated when you wet the electrode
areas and put on the chest belt monitor; the chest belt
Monitor shuts off when it is removed and the electrode
areas are dried. If the chest belt monitor is not dried
after each use, the battery may be drained
prematurely
Store the chest belt monitor in a warm, dry place.
Do not store the chest belt monitor in a plastic bag
or other container that may trap moisture.
Do not excessively bend or stretch the sensor unit
when using or storing the chest belt monitor.
Clean the sensor units using a damp cloth- never
use alcohol, aba dives, or chemicals. Hand wash
and air dry the chest belt.
If the chest belt monitor does not function
properly, try the suggestions below.
Make sure that you are wearing the chest belt
monitor as described at the left. Note: If the chest
belt monitor does not function when positioned as
described, move it slightly lower or higher on your
chest.
Use saline solution such as saliva or contact lens
solution to wet the two electrode areas on the
sensor unit. If chest belt readings do not appear
until you begin perspiring, re-wet the electrode
areas.
To use the chest belt heart rate, position yourself
near the console. It is recommended that the user
be within arm’s length of the console.
The chest belt monitor is designed to work with
people who have normal heart rhythms. Chest
belt reading problems may be caused by medial
conditions such as premature ventricular
contractions (pvcs), tachycardia bursts, and
arrhythmia
The operation of the chest belt monitor can be
affected by magnetic interference caused by high
power lines or other sources, if it is suspected that
this is a problem, try relocating the elliptical.
HOW TO WEAR THE WIRELESS CHEST BELT
The monitor has two components: a chest belt and a
sensor unit (see the drawing below). Insert the tab on
one end of the chest best into one end of the sensor
unit, as shown in the insert drawing. Press the end of
the sensor unit under the buckle on the chest belt. The
tab should be flush with the front of the sensor unit.
Next, wrap the chest belt monitor around your chest
and attach the other end of the chest belt to the sensor
unit. Adjust the length of the chest belt, if necessary.
The chest belt monitor should be under your clothes,
tight against your skin, and as high under the pectoral
muscles or breasts as is Comfortable. Make sure that
the logo on the sensor unit is facing forward and is
right-side-up Pull the sensor unit away from your body
a few inches and locate the two electrode areas on the
inner side (the electrode areas are covered by shallow
ridges). Using saline solution such as saliva or contact
lens solution, wet both electrode areas. Return the
sensor unit to a position against your chest.
Содержание T-300PX
