GNATUS Syncrus G8, Руководство пользователя

Страница: 29 / 36

29
Sensibility to predictable environmental conditions in regular use conditions
Warnings
- Syncrus G8 Dental Chair requires special care in terms of electromagnetic compatibility
and needs to be installed and put into operation according to information on electromagnetic
compatibility provided in this manual.
- The communication equipment of mobile and portable RF may affect electric medical
equipment.
- The use of a cable, transducer or other accessory different from those specified in this
manual, and/or the replacement of inner components of those equipment may result in the
increasing of emissions or reduction of the electromagnetic immunity of the equipment.
- It is not convenient that the Syncrus G8 Dental Chair be used near to or Piled over other
equipment, in case of the use near to or piled over is necessary, it is convenient that the
Syncrus G8 Dental Chair be observed to check if it is working properly in the configuration
to be used.
Precaution and warnings “during the installation” of the equipment
- This equipment can only be unpacked and installed by an Gnatus authorized technician, under the
penalty of losing the warranty, as only them possess the information, the proper tools and the required
training for carrying out this task.
- Gnatus does not take this responsibility for damage or accidents caused due to a bad installation
performed by a technician non-authorized by Gnatus.
- Only after the equipment is installed and properly tested by the Gnatus authorized technician, it will
be ready to start the working operations.
- Position the unit in a place where it will not get wet.
- Install the unit in a place where it will not be damaged by the pressure, temperature, humidity, direct
sunlight, dust, salts.
- The unit should not be submitted to inclination, excessive vibrations, or blows (including during
transportation and handling).
- This equipment was not planned for use in an environment where vapors, anesthetic mixtures
inflammable with air, or oxygen and nitrous oxide can be detected.
- Check the voltage of the equipment at the moment of executing the electrical installation.
- Before the first use and/or after long interruptions from work such as vacations, clean and disinfect
the equipment.
PRECAUTIONS, RESTRICTIONS AND WARNINGS