GNATUS Syncrus G3, Руководство пользователя

Страница: 32 / 36

32
Water Unit
- Ejector without suction.
- Insufficient air pressure
from compressor.
-Vacuum pump is turned off.
-Filter clogged with particles.
-Filter lid misplaced.
-Chair fuse burned.
-Chair’s main switch is turn
off.
-Adjust air flow.
-Turn on the vacuum pump.
-Remove and clean filter.
-Remove lid and place it
correctly.
-Turn off the chair from
mains power and request a
Technician presence.
-Turn on chair’s switch.
-Handpiece with low speed. -Inlet pressure below speci-
fied (80 PSI).
-Adjust inlet pressure (80
PSI).
-No water from handpiece
spray.
- Insufficient air pressure
from compressor.
-Reservoir run out of water.
-Closed terminal.
- Adjust air flow.
- Put filtered water in reser -
voir.
- Open terminal.
-Handpiece is not working. - Compressor disconnected.
-
Plug the compressor in.
-No water from syringe. -Reservoir run out of water.
-Compressor disconnected.
-Put filtered water in reser -
voir.
-Plug compressor in.
- Bowl’s water flow and cup
filling are not operating.
- Lack of water
- Water valve is closed
- Power cut
- Chair fuse burned.
-Chair’s main switch is off or
terminal box is disconnected.
- Check the water supply
- Open the water valve
- Check the energy supply
- Turn off the chair from
mains power and request a
Technician presence.
- Switch the main switch on
or connect the terminal box
-When Bio-system is ope-
rated no disinfectant come
from handpiece terminals.
-Bio-system reservoir run
out of water.
- Chair fuse burned.
-Main or chair switch is off
-Put disinfectant in the re-
servoir.
- Turn off the chair from
mains power and request a
Technician presence.
-Switch main/chair switch
on.
Upon coming across any problem in operation, follow the instructions below to
check and repair the problem, and/or get in touch with your representative.
UNFORESEEN EVENTS – SOLUTION OF PROBLEMS
Problem Probable cause Solution