GNATUS 300053096, Руководство пользователя

Страница: 61 / 104

61
Recharging the battery
The LCD Display shows the actual battery charge, when the scale is full, it means that
the battery charge is complete. If there’s not enough charge, the scale will blink, meaning
that the battery charge is about to end. At this point the beep will sound for 3 seconds and
the instrument will turn off after 60 seconds.
To recharge the battery again you should connect the equipment to the charger for, at
least, 4 hours. (A new battery must be charged for 8 hours or more). The signal will be on
during the battery charging.
When the equipment is connected to the charger, it will shut off
automatically (Non-operating), and the beep will sound 3 times indicating
that the connection is correct.
The equipment can only be turned on again when the battery charger
connector is disconnected.
These information also make part of the Manual of Installation and
Maintenance of the equipment that can be found with the authorized
Gnatus technician.
PRECAUTIONS, RESTRICTIONS AND WARNINGS
Recommendations for the dental equipment maintenance
Your Gnatus equipment has been designed and developed according to the standards of
modern techology. Similarly to other kinds of equipment, it requires special care, which is
many times neglected due to several reasons and circunstances. Therefore, here are some
important reminders for your daily routine. Try to follow these simple rules, which will save
you a lot of time and will avoid unnecessary expenses once they start making part of your
working procedure.
- Position the equipment in a place where it will not get wet.
- Install the equipment in a place where it will not be damaged by pressure, temperature,
humidity, direct sunlight, dust, salts, or sulfur compounds.
- The equipment should not be submitted to inclination, excessive vibrations, or blows
(including during transportation and handling).
- This equipment was not planned for use in an environment where vapors, anesthetic
mixtures infl ammable with air, or oxygen and nitrous oxide can be detected.
- Before the first use and/or after long interruptions from work such as vacations, clean
and disinfect the equipment.
- Check that the measurement plug is firmly connected to the inlet. The inadequate
connection can hinder the measurement.
Precautions and warnings “during the installation” of the
equipment