GMS B36, Руководство по эксплуатации и техническому обслуживанию

Страница: 21 / 29

B36
20
WARNING!!!
In order to fix the faults and determine the electricity malfunction if it is required to open the
power panel, power connection of the machine must be turned off and competent technicians should
make the maintenance.
12. MAINTENANCE AND LUBRICATION INSTRUCTIONS
It is important to make maintenance correctly in order to extend service life of the machine and to
ensure safe bending. We suggest for each user to set up a secure system for control and maintenance of
the machine. The following descriptions are given for reference. Number 140 gear oil is used in
machine's reducer unit.
Daily maintenance of the machine
•
Clean dust and scales on the machine with a brush.
•
If the machine is running outdoors it must be protected from rain water when raining.
•
Machine should be checked if there is extraordinary voice or not.
Weekly maintenance of the machine
•
Parts driving machine bending plates should be cleaned and lubricated.
•
Machine adjusting lever mechanism should be cleaned and lubricated.
Monthly maintenance of the machine:
•
Bending pins and bending plates should be checked and any cracked or skewed parts mustn't be
used.
•
Reducer should be checked if there is oil leakage or not.
•
Machine's sensor display should be checked if it has dirt on it or not and also the lamp behind it
should be checked if it is working or not.
Semi-annual maintenance of the machine:
•
All the bolt connections of the machine should be checked.
Annual maintenance of the machine:
•
Oil of the machine should be changed.
•
If it is out of order seals and bearings should be changed.
•
Any skewed, cracked, worn parts should be checked and replaced.
10. FAULTS AND SOLUTION OFFERS
Any faults those might arise when running the machine, and their causes and solutions are given in the
table below.
WARNING!!!
In order to fix the faults and determine the electricity malfunction if it is required to open
the power panel power connection of the machine should be turned off by switching the main
switch to 0 positions and competent technicians should make the maintenance.