GMS B36, Руководство по эксплуатации и техническому обслуживанию

Страница: 18 / 29

B36
17
11.4. Hook Bending Settings (180°):
It is set with the same method carried out in bent bar bending by pressing the P3 button on the
control panel.
NOTE: The required angle is set for P3 BUTTON by moving the figure: 10 switch pin 3 to left and
right.
Figure12: Hook Bending demo
11.5. Stirrup Bending:
Stirrup Bending Mode:
Prog. On Stirrup Bending Setting Systems:
PROGRAM OFF-ON SWITCH BUTTON should be at program ON position. 90° angle which is
used in stirrup bending should be set to P2 button before the program is taken to ON position, the
SWITCH BUTTON should be turned to program non position (clockwise) after the stirrup tip bending
with 135° are set to P3 button. After turning the SWITCH BUTTON, P1 button should be pressed
once. Afterwards P1-P2-P3 buttons will blink only once. This warning indicates that the machine is
ready for programming. After this process, programming starts according to the required bending
angle. For example: Programming for performing stirrup bending shape is described below.
(Figure 9-
6) (Figure 9-
6)
Bending pin mounted
with safety purpose