GMS B36, Руководство по эксплуатации и техническому обслуживанию

Страница: 16 / 29

B36
15
11.2.
Bent Bar Bending setting (45°):
Prog. Off Normal Bending Setting Systems :
Before starting angle setting, it should be ensured that there is no any material on the machine
other than the bending equipment.
The Switch button should be taken to OFF position and P1 button should be pressed. There are
3 Switch Pins with same heights on the bending disc. Rotation direction should be controlled by taking
the machine to MAN position. Appropriate bending angle for venting should be set by trying the
switch pin (P1)
(Figure 1-3) throughout the holes on the bending disc (A and B directions). As long as
the switch pins (A and B) are taken closer to the measurement sensor (Figure 1-4) from both sides, the
bending angle decreases. Conversely as they are taken away from the measurement sensor the bending
angle increases.
NOTE : For P1 button Switch pin=1; For P2 button Switch pin=2; For P3 button Switch pin=3 are used
to set the angle.
After the setting procedure is completed the iron for bending and bending equipment must be
put on the machine and it should be available for bending as it is shown in Figure 4a-4b-4c-4d . It
should be mounted according to the diameter (if it is smaller than 16 mm the retainer and if it is bigger
than 16 mm the appropriate bending sleeve) of the iron to be bent (
Figures 4a-4b-4c-4d ). Lastly when
the bending disc returns after bending the iron it should be mounted on the bending plate on the front
side of the iron for safety to prevent any injury due to movement of the iron.
(Figure 10). Setting
process should be completed by ensuring the iron to be bent (Figures 4a-4b-4c-4d) positioned parallel
by moving bending plates backward and forward with the help of the adjustment spanner. (Figures 4a-
4b-4c-4d)
For serial bending, machine should be taken to AUTO position and then bending should be
made.
NOTE : When the machine is at the MAN position the bending disk revolves, after bending is
completed and the machine is on the holding position it stops. When the machine is at the AUTO
position bending disk stops at holding position by completing the bending just pressing the Foot Pedal
only once. When the machine is at the AUTO position, the machine can be stopped by pressing the
1 Switch pin =P1
2 Switch pin =P2
3 Switch pin =P3
4 Measurement Switch
5 Stop Switch
5
1
2
3
4
B
DIRECT
ION
A
DIRECT
ION