18
FIBER INSTALLATION
Insure that the remote control and the power supply is connect-
ed to the unit before plugging into the power source. After sup-
plying power, the LCD panel on the remote unit should power up
with the following display.
Select the option by pressing
the relevant blue button under
either YES or NO depending on
the type of installation you
wish to carry out and the
plates fitted to the machine.
The buckle sensor utilizes plates with the buckle shuttle
-
this
can be seen in the photo at the top of the previous page. Should
the wrong selection be made this can be altered in the menu
system, this is detailed later in this section
.
Once the selection is made, a confirmation screen is briefly dis-
played followed by one of the screens below:
If a job has not been finished then it will remain active in
memory and the screen on the right will be visible. It is then pos-
sible to either resume that job or start a new job. The blue
buttons allow navigation through the menus and the functions
of these buttons are displayed on the screen. Starting a new job
will present you with the following display.
