XRS-330C
21
PROGRAMMING THE SCAN MEMORIES
Each Scan Group has its own separate channel memory allowing you complete
freedom to program your choice of channels into each group.
To add/remove channels from the selected scan memory:
1.
Select the required channel using the
or
key.
2.
Check to see if the
icon is displayed on that channel.
•
If
is displayed, the selected channel is already in the scan
memory. To remove it, press and hold
SCAN
. A low beep will be
heard and
will disappear.
•
If
is not displayed, the selected channel is not in the scan
memory. To add it, press and hold
SCAN
. A high beep will be heard
and
will appear on that channel.
Repeat to add or remove other channels in the scan memory.
NOTE
: When adding channels to Net-Scan, please consider the following:
•
The transmitter on your radio is inhibited on channels 22, 23 and
channels 61, 62, 63 as required by the ACMA. This makes these
channels unsuitable for use as Net-Scan channels.
•
You should not include any repeater channel unless you have confirmed
that the channel is not allocated to repeaters in your area. Using an
active repeater channel in Net-Scan may result in interference to
repeater users on that channel.
AUTO SKIP
While scanning, if an active channel in your Scan Group becomes a nuisance
by constantly interrupting the scan, briefly press
or
while the radio is
paused on that channel. The busy channel will be temporarily removed from the
Scan Group to allow time for the channel to become clear again and scanning will
continue from the next channel in the sequence. After 30 seconds the skipped
channel will be reinstated in the scan sequence.
If the unwanted active channel continues to interrupt the scan even after the
30 second skip period has elapsed, hold SCAN while the radio is paused on that
