TX6600PRO
INSTRUCTION MANUAL
40
3.
Press the
MENU
F
key.
4.
If Network Scan is switched off, ‘OFF’ will be displayed. Rotate the
Channel
knob or press the
keys to enable Network Scan and
select a suitable CTCSS/DCS tone.
i.
Rotate the
Channel
knob clockwise or press the
key to enable
CTCSS and select CTCSS tones from 01 to 50.
ii.
Rotate the
Channel
knob counter-clockwise or press the
key to
enable DCS and select DCS tones from 001 to 104.
NOTE:
Advancing upwards past CTCSS tone 50 will automatically
cycle into the DCS tone set. Similarly, stepping downwards below DCS
tone 001 will automatically cycle into the CTCSS tone set.
5.
When the desired CTCSS/DCS tone is displayed hold the
MENU
F
key to
exit or wait for the menu to time-out.
Refer to the CTCSS/DCS tone table in this manual for details of tone values.
NOTE:
Selecting Netscan CTCSS/DCS tones does not affect the Global CTCSS/DCS
tone setting used for normal CTCSS/DCS operation.
To Select Network Scan for scanning
Briefly press
MENU
F
then
SCAN
OS/GS
to cycle through the scan groups until
NETWK
is
displayed.
Programming channels into Network Scan
All radios in your Network Scan group must have the same channels programmed
into their Network Scan memory. Your radio’s Network Scan memory has been
factory programmed with 43 of the available 80 channels. The remaining 37
channels, consisting of the 32 repeater input/output channels, 2 telemetry
channels and 3 reserved channels, have not been included to minimise the risk of
interference to other services on these channels.
To add or remove Network Scan channels
Follow the procedure to ADD or REMOVE your desired channels as described
above.
IMPORTANT:
If adding channels to your Network Scan, please consider the
following:
The transmitter on your radio is inhibited on channels 22, 23 and channels 61, 62,
63 as required by the ACMA. These channels are therefore unsuitable for use as
Network Scan channels.
