T X 3 5 0 0 S
I N S T R U C T I O N M A N UA L
PA G E 1 9
Removing the radio
Fitting the microphone
The microphone uses a miniature 6 pin telephone style
plug which fi ts the TX3500S’ microphone socket. The
TX3500S has two microphone sockets – one on the front
panel and one on the rear panel. The microphone can be
plugged into either socket. If connecting the microphone
to the rear socket, an optional extension cable LEM6P is
available to bring the microphone connection to a more
accessible location.
To fi t the microphone: Front
1. The front microphone cover is a press fi t. To remove, simply
insert the end of a paper clip or similar into the small slot
in the edge of the cover and lift the cover away from
the panel.
2. Place the microphone plug so the plastic tab faces
downwards, then press plug into the socket until
it ‘clicks’.
3. Gently press the rubber strain relief into the hole
surrounding the socket so that the slot around the strain
relief fi ts neatly inside the lip of the hole.
Lift panel here
Plastic tab
v
Rear
1. The rear microphone cover hinges from the top. Simply
lift the cover from the bottom. The cover will remain
connected to the chassis.
2. Place the microphone plug so the plastic tab faces
downwards, and press the plug into the socket until
it ‘clicks’.
Rear microphone
cover
Lift microphone
cover
Plastic tab
