GME Electrophone TX4200 Series, Инструкция по эксплуатации

Страница: 21 / 33

inform you of the call.
When you return to your vehicle, your TX4200
is displaying the callers Ident and is sitting on
the channel on which the call was received. You
are then able to return the call.
Similarly, the Page function can be used to alert
you to calls made to your TX4200 Base station.
This leaves you free to walk around your office,
building or property with a Paging receiver,
knowing that you will be alerted to any calls
made to your base station.
Page Channel
The Page channel is factory set to UHF CB
channel 23
( s e e s e c t i o n o n d e a l e r
programmable options)
. If channel 23 is not
suitable for use in your area you can arrange
for your dealer to reprogramme it to another of
the 40 UHF CB channels. If using the TX4200
with the PG4000 paging receiver we
recommend you leave it set to channel 23
because this is the channel on which the
PG4000 is set.
Programming the PAGE Ident
The PAGE Ident can be programmed and
stored in it’s own separate Page memory. It is
programmed exactly the same as any other
Selcall Ident and is stored by pressing the
Volume knob.
The Page Ident must be programmed to match
the Ident of the receiver you will use to receive
the Paging call.
1. Select the 'Call To' mode by briefly pressing
the
CALL
button.
'CALL TO'
will be
displayed.
The right hand digit of the 5 digit Ident is
now flashing. This flashing digit indicates the
digit to be programmed.
2. Select the number required in the flashing
digit position by rotating the channel selector
switch left or right.
3. When the required number is displayed,
briefly press the channel knob. A high beep
will be heard and the next digit will flash.
4. Repeat steps 2 and 3 to programme all 5
Paging Ident digits as required.
Once the Ident has been entered, you have 20
seconds to store it (otherwise the 'Call To' mode
will be cancelled and the Ident will be lost).
• To store the Ident into the Page memory,
press and hold the Volume knob for a few
seconds. During this time the Page Ident will
flash, after which a high beep will be heard.
The Ident is now stored.
Viewing the Page Ident Memory
To view the Ident stored in the Page memory:
1. Select the CALL TO mode using the
CALL
button.
2. Briefly press the Volume knob.
The Page Ident will appear under
'CALL TO'
on the display.
Selecting the Page Mode
The Page function can be used either while
monitoring a single channel or while scanning in
either of the two scan modes.
Single Channel Use
1. Check that you have the correct Pager Ident
stored in the Page memory
(see “Viewing
the Page Ident memory”)
. Unless you have
specifically reprogrammed it, it should not
have changed.
2. Rotate the channel selector switch to select
the channel you wish to monitor.
3. Select the Page mode as follows:
21
VOLUME
PUSH
PAGER/
OFF
CALL TO
SCAN
MEM
DUP OS/GS
2 3 1
M