GME Electrophone TX4200 Series, Инструкция по эксплуатации

Страница: 17 / 33

2. If required, programme the displayed Ident
as described earlier.
3. When the required Ident is displayed, press
and hold (for about 3 seconds) one of the
three buttons below the display labelled 1, 2
or 3. While the button is being held, all 5
Ident digits will flash, then a high beep will
be heard as the Ident is stored.
Recalling Selcall Idents from Memory
1. Select the 'Call To' mode. CALL TO will be
displayed.
2. Briefly press memory button 1, 2 or 3
(whichever contains the Selcall Ident you
wish to recall). The recalled Ident will be
displayed.
3. To transmit the recalled Ident, press and
hold the CALL button.
SELCALL QUIET MODE
The Selcall Quiet mode can be programmed for
operation on individual channels. This means
that some channels can be set for quiet
operation (will only unmute when your Selcall
Ident is received) while others can be left open
(allowing ALL signals to be heard).
Two programming steps are required for full
Quiet operation.
Step 1
allows you to mark the required QUIET
channels with a
'Q'
. This indicates that only
these marked channels will be fully muted when
the QUIET mode is selected.
Step 2
activates the QUIET mode. When the
QUIET mode is activated, only those channels
marked with
'Q'
will remain muted to all signals
unless your Selcall Ident is received. Channels
NOT marked with
'Q'
will remain as open
channels and will allow ALL signals to be heard
even though the QUIET mode is active.
When your TX4200 leaves the factory, it does
not have any channels programmed with
'Q'
.
Marking Channels for QUIET operation
To programme an individual channel so that it
will operate as a QUIET channel when the
QUIET mode is activated:
1. Select the required channel. (If the receiver
is Scanning or in another operational mode,
cancel the mode and return to normal
operation).
2. Press and hold the Squelch knob until a high
beep is heard.
'Q'
will appear on the display
to the right of the channel number indicating
the channel is now set for QUIET operation.
3. Repeat steps 1 and 2 to programme any
other channels required for QUIET
operation.
Unmarking Channels set for QUIET
Operation
The procedure for unmarking QUIET channels
is exactly the same as for marking them:
1. Select the channels you wish to unmark.
There will be a
'Q'
on the display when that
channel is selected.
2. Press and hold the Squelch knob until a low
beep is heard.
'Q'
will disappear from the
display indicating the channel is no longer
set for QUIET operation.
Operating in the QUIET Mode
Channels marked with a
'Q'
will not actually
operate as QUIET channels until the QUIET
17
CHANNEL
PUSH
QUIET
SQUELCH
PUSH
PRI
Q
SCAN
MEM
DUP OS/GS
2 3 1
M
CALL TO
SCAN
MEM
DUP OS/GS
2 3 1
M