LEDTASKtapeINST
PAGE 5 OF 10
Wet Location
Wet location is a designation that usually means
‘outdoor rated’. LTR-WP Series wet location tape
is protected by a silicone sheath that protects the
tape within from moisture and inclement weather.
To insure proper operation, install only in locations
that are at least 5 feet away from swimming pools
and spas.
Turn Power Off at Circuit
Breaker Before Installing
Prior to installation, verify that all components (LED
tape, connectors, mounting clips, channels and
power supplies) are compatible.
Determine Location and
Prepare Mounting Surface
Locate area where LineDRIVE power supply is to
be mounted. Make sure area is clean and free of
dust and any debris that may hamper installation or
get in the way of wiring. Please make sure that the
wire gauge that you select has voltage drop,
amperage rating and type (in-wall, dry or wet
location, etc.) is factored in.
Un-Boxing and Organizing
Pre-Configured Products
Your LTR-WP Series Wet Location Tape Application
has been pre-configured, cut and packaged for you.
Open box and remove contents carefully. Lay tape
out over application area and insure that all mea-
surements are accurate. If not, return in original
packaging.
WARNING!
DO NOT CONNECT DIRECTLY
TO 120V CURRENT!
DO NOT SUBMERGE
DIRECTLY INTO WATER.
WET LOCATION TAPE IS
CUT AND CAP ONLY.
LEDTask™ Flexible LED Tape
LTR-P WP Series
Wet Location LED Tape
90
C R I
+
24
VOLT
FIELD
C U T T A B L E
65
IP
2
CLASS
24
TITLE
WET
L O C A T I O N
DO NOT INSTALL
IN SHOWER, SPA
OR POOL
DO NOT IMMERSE
LED STRIP
IN WATER
Verify that power is off
before proceeding.
