LEDTASKtapeINST
PAGE 2 OF 10
Dry Location
Dry location is a designation that usually means ‘in-
door’. LTR Series dry location tape is presented in a
copper bus that is not encapsulated with a silicone
sheath. To insure proper operation, install only in
locations that are not exposed to moisture, steam,
inclement weather or leaks of any type.
For Wet
Location, go to page 5.
Turn Power Off at Circuit
Breaker Before Installing
Prior to installation, verify that all components (LED
tape, connectors, mounting clips, channels and
power supplies) are compatible.
Verify that power
is off before proceeding.
Determine Location and
Prepare Mounting Surface
Locate area where LineDRIVE power supply is to
be mounted. Make sure area is clean and free of
dust and any debris that may hamper installation or
get in the way of wiring. Please make sure that the
wire gauge that you select has voltage drop,
amperage rating and type (in-wall, dry or wet loca-
tion, etc.) factored in
Layout and Pre-Configure
Components Before You
Begin Installation
Locate area where LineDRIVE power supply is to
be mounted. Make sure that this space is free of
obstructions and can be easily reached for
mounting or maintenance.
WARNING!
DO NOT CONNECT DIRECTLY
TO 120V CURRENT!
PLEASE READ PREVIOUS PAGE
AND FAMILIARIZE YOURSELF
WITH ALL INSTRUCTIONS
BEFORE INSTALLING
LEDTask™ Flexible LED Tape
LTR-E, LTR-P and LTR-S Series
Dry Location LED Tape
90
C R I
+
12
VOLT
DRY
L O C A T I O N
FIELD
C U T T A B L E
20
IP
24
VOLT
2
CLASS
24
TITLE
Use your mind before you unwind!
Please follow all applicable NEC
and local wiring codes.
Follow maximum length
tolerances when using tape.
Max. Length = maximum run length
from one power feed.
Verify that power is off
before proceeding.