LEDTASKtapeINST
PAGE 3 OF 10
Cutting Tape
LED tape is unique in the fact that it is the only
lighting ‘fixture’ that you can cut to length with
only a pair of scissors. We made it easy for you to
do that! Find the cut mark closest to your desired
length and cut cleanly, across the marks.
Fig. 1
Peel back adhesive 1/2” to expose back of tape.
You are now ready for attaching a connector
Fig. 2.
If you’re at the end of your run, you’re done.
Attaching Connector
Using Sure-Tite Connector (ST or EST Series)
Loosen screws at end of connector. Slide tape in
firmly, pushing it all the way until it stops. Make
sure that tape is seated firmly, creating a tight bond
with the connector. Snug-tight screws,
do not
overtighten.
Fig. 3.
Attaching Power to Tape
Connector
Use same procedure for connecting Sure-Tite
connector. The other end of connector is wired into
your LineDRIVE power supply. Please consult
power supply instructions for a step by step for
this easy procedure.
Make sure that you you are
connected to the same polarity.
Warning
Make sure that tape is pressed firmly into
connector, insuring that tape contacts are firmly
seated into connector. Improper or loose seating
can cause tape to short out or not perform properly.
Test tape installation by powering up before
permanently mounting. If tape does not
perform satisfactorily, check our FAQ / Trou-
bleshooting tips on page 7.
LEDTask™ Flexible LED Tape
LTR-E, LTR-P and LTR-S Series
Dry Location LED Tape
Cut on mark
Fig. 1
1/2”
Expose back of
strip before
connecting
Fig. 2
SureTite Connector
Fig. 3
Flip open
and seat tape
firmly under
terminals
Fig. 4
Cut marks are spaced at
different lengths depending on
the type of tape. All cut marks
are clearly marked on tape.
